Skip to main content

Using Heart Rate in Lactate and PPD Tests

Heart rate can complement power or speed data in lactate and PPD tests. A useful heart-rate relationship depends on recordings from appropriate effort durations and intensities.

Lactate testing

• For stages long enough for heart rate to stabilize, record the average of the final 30 seconds of the stage.

• Include at least three sub-threshold stages during warm-up, lasting approximately 2–3 minutes at different intensities, to capture lower-intensity values.

• Do not enter heart-rate values for very short maximal efforts, such as sprints or one-minute all-out efforts, if they are too short for heart rate to reach its maximum. These values can distort the heart-rate-to-power or heart-rate-to-speed regression.

• If the athlete’s known maximum heart rate is higher than the maximum measured during the test, enter it using the Maximum Heart Rate manual override at the top-right of the lactate Excel template.

• Complete the remaining required power/speed, duration, lactate and heart-rate fields in the Excel template.

PPD testing

Record heart rate throughout the session and upload complete .fit recordings, rather than recordings clipped to the maximal efforts. A broad range of power or speed values helps produce a more informative heart-rate relationship.

How to read the heart-rate relationship

• The graph relates power or speed (x-axis) to heart rate (y-axis).

• The fitted line is described by its slope and zero offset; R² indicates how closely the measured points fit the line.

• A PPD recording may have a lower R² because heart rate responds with a delay when effort increases or decreases.

• Interpret the relationship in light of fatigue, sleep, temperature, stress and other conditions affecting heart rate.

Did this answer your question?