Incremental or step tests
Use at least four intensities / steps / increments across a meaningful exercise range. With VO₂ measurement, each step should last at least four minutes, preferably five minutes. This allows the first two to three minutes, while VO₂ and potentially VCO₂ adjust to the workload, to be excluded while still leaving enough stable data for averaging. Use this duration for all steps, not only the lower-intensity ones.
If VO₂ is not measured, three-minute steps are generally sufficient. Measure lactate after each step. Continue post-exercise sampling to capture the peak lactate value; if two consecutive measurements are no longer increasing, the peak can generally be considered reached.
High-intensity all-out efforts
Use maximal efforts lasting at least two minutes to capture the athlete’s response at a known, constant workload or speed. Measure lactate immediately before and after the effort and continue sampling until the
peak is established. Two consecutive non-increasing lactate measurements indicate that the peak has most likely been reached.
Gas analysis is not mandatory. However, VO₂ can be measured during sufficiently long efforts - approximately longer than 2½ minutes - to assess VO₂max where the athlete reaches it. A constant-workload effort also enables meaningful analysis of exercise economy and the lactate response.
Sprint efforts
For PPD sprints in cycling or running, the athlete should remain at complete physical rest during the final two minutes before the sprint. In cycling, do not pedal and ensure that the power meter records no power
during this preparation period.
For lactate-based sprint assessments, collect a baseline lactate sample before the sprint and continue post-effort sampling to establish the peak lactate concentration.
Direct VO₂max ramp testing
When gas analysis is available, a progressive ramp test can be used to determine VO₂max. If this method is chosen, use increments lasting approximately 30–60 seconds. The ramp should lead to exhaustion within roughly 5–10 minutes; a practical protocol target may also be described as approximately 6–12 minutes.
Although time-efficient, a ramp test is not our preferred method for a broad metabolic assessment. It primarily supplies a VO₂max result, without providing the same opportunities to analyze blood lactate and
exercise economy at fixed intensities.
We generally recommend the high-intensity all-out effort described above when it is long enough to elicit VO₂max. Because the workload or speed is constant, it can also be used for lactate measurements and
assessment of exercise economy.
