Skip to main content

Customize Visualizations

Configure the charts in an athlete’s test directly where you analyze the results

How to customize a chart

Open an athlete’s test and go to the relevant chart. Select Customize or Customize Graph to change the settings directly in that visualization. Available controls depend on the chart, sport and test.

General sport settings may include the reference system or units used to display speed, pace or power, such as km/h, m/s, W or W/kg.

Metabolic Fingerprint (radar chart)

Choose which physiological metrics appear on the radar chart and adjust the applicable reference units. You can also select an Athlete Category, which determines the comparison ranges and normalized chart

positions. Changing the category changes the reference interpretation, not the athlete’s measured results.

Default categories use fixed limits; limits for custom categories can be edited where permitted.

Physiological Performance Benchmarks (meters)

These meter charts use the same sport reference settings and Athlete Categories as the Metabolic Fingerprint. In addition, customize:

• Which benchmark meters / metrics are displayed.

• Which value controls each meter needle, for example absolute versus body-mass-relative VO₂max.

• Which numerical metrics and additional values appear beneath each meter.

Performance Development Charts

Create and configure up to three charts for an athlete’s test history. For each chart, select multiple parameters to be plotted on the available Y-axes. This lets you compare how different physiological metrics

change across tests.

Select how the X-axis positions test results: either equally spaced data points or spacing proportional to the actual time between test dates.

Load Characteristics

Open the Load Characteristics page and customize the axis reference displayed on its graphs. Depending on the graph, choose a single X-axis or add a secondary X-axis and select the reference units.

Test Data – lactate curve

For a lactate test, open the Test Data page and customize the lactate chart directly. Choose the X-axis reference and which vertical reference lines should be visible, such as LT1, MLSS or VO₂max power where available.

You can also select a Training Zone Template to display its zones as colored background bands. Individual zones in the chosen template can be shown or hidden. If heart-rate data are available, the test view can also display heart rate.

Did this answer your question?